Rangemaster ECL90HPNGFBL/BL, User Manual & Installation & Service Instructions

9

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Provision of Ventilation

This appliance is not connected to a combustion products 

evacuation device. Particular attention shall be given to the 

relevant requirements regarding ventilation.

In the UK

The room containing the hob should have an air supply 

in accordance with BS 5440 Part 2. All rooms require an 

openable window or equivalent, while some rooms require a 

permanent vent in addition to the openable window. The hob 

should not be installed in a bedsitting room with volume less 

than 20m³. If it is installed in a room of volume less than 5m³ 

an air vent of effective area 100cm² is required; if it is installed 

in a room of volume between 5m³ and 10m³, an air vent of 

effective area 50cm² is required; while if the volume exceeds 

11m³, no air vent is required.
If there are other fuel burning appliances in the same room, 

BS 5440 Part 2 should be consulted to determine the requisite 

air vent requirements.

In the Republic of Ireland

Reference should be made to the current edition of IS 813, 

which makes clear the conditions that must be met to 

demonstrate that sufficient ventilation is available.

Location of the Hob

The hob may be installed in a kitchen/kitchen diner but NOT 

in a room containing a bath or shower.

NOTE

: An appliance for use on LPG shall not be installed 

in a room or internal space below ground level, e.g. in a 

basement.

Conversion

All models are supplied set for use on group H natural gas. 

A conversion kit for LP gas is included with the appliance. 

See the instructions that are supplied with the conversion 

kit. After converting the appliance please attach the Gas 

Conversion sticker over the appropriate area of the data 

badge; this will identify the gas type the appliance is now set 

for.
This appliance is designed for domestic cooking only. Use for 

any other purpose could invalidate any warranty or liability 

claim.
You will need the following equipment to complete the hob 

installation satisfactorily:

• 

Gas Pressure tester

• 

Flexible gas hose

• 

Multimeter

You will also need the following tools:

• 

Electric drill

• 

Jigsaw

• 

Steel tape measure

• 

Cross head screwdriver

• 

Pencil

• 

Adjustable spanner

• 

Sharp knife

Checking the Parts

Check that the appliance is in a good condition after having 

removed the packaging. In case of doubt, do not use the 

appliance and contact the retailer.

n

Never leave the packaging materials (cardboard, 

plastic bags, polystyrene foam, etc.) within children’s 

reach since they could become potential sources of 

danger.