25
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Conversion to Another Gas
If the appliance is to be converted to another gas do the
conversion at this point. See the conversion section of these
instructions.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.
Fitting the Handles and Handrail
Remove the 4 mm Allen screws from the doors
(Fig. 7.10)
. Fit
the door handles and secure using the 4 mm screws
(Fig. 7.11)
.
n
n
The handles should be above the fixings.
Remove the 4 mm Allen screws from the top corners of the
fascia
(Fig. 7.12)
. Fit the handrail in position and secure using
the 4 mm screws.
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
ArtNo.215-0027 - Elan handle blanking plugs
ArtNo.215-0026 - Handle gaskets fixed
Art No 215-0028 - Handrail fascia fixings
Fig. 7.10
Fig. 7.11
Fig. 7.12
Summary of Contents for Elan 90 Dual Fuel
