Rangemaster Longstock 90 Induction, User'S Manual & Installation Instructions

INSTALLATION

Check the appliance is electrically safe when you have finished.

27

ArtNo.110-0004 - 110 Cooker min spacings

5 mm

5 mm

Height to Hotplate

905 mm min

930 mm max

Height to Flue Trim

905 mm min

930 mm max

650 mm min

410 mm min

410 mm min

Wall

Wall

910 mm

75 mm min

75 mm min

check cookerhood instructions for actual dimensions

900 mm

ArtNo.090-0024 - 90 induction door clearances 

130 mm min

ArtNo.090-0028 - 90 cooker min spacing GENERIC

75 mm

min

75 mm

min

650 mm

min

905 mm min

930 mm max

Positioning the Cooker

Fig. 8.1

 and 

Fig. 8.2

 show the minimum recommended 

distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.

Fig. 8.1

 and 

Fig. 8.2

 Cookers installed into recess: The cooker 

must have side clearance 

ABOVE

 hob level of 75mm up to a 

height of 410mm. This can be reduced to 25mm if the surface 

of the side wall is non-combustible.
A minimum space of 650 mm is required between the top of 

the hob and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the 

hood manufacturer’s instructions.
**Any splashback must be fitted in accordance with the 

manufacturers instructions. Allowance should be made for 

the additional height of the flue trim, which is fitted to the 

cooker hob. 
Surfaces of furniture and walls at the sides and rear of the 

appliance should be heat, splash and steam resistant. Certain 

types of vinyl or laminate kitchen furniture are particularly 

prone to heat damage and discolouration. We cannot accept 

responsibility for damage caused by normal use of the 

cooker to any material that de-laminates or discolours at 

temperatures less than 65 °C above room temperature.

DO NOT

 box the cooker in – it must be possible to move the 

cooker in and out for cleaning and servicing.
If the cooker is near a corner of the kitchen, a clearance of 

130 mm is required to allow the oven doors to open  

(

Fig. 8.3

). The actual opening of the doors is slightly less, but 

this allows for some protection of your hand as you open the 

door.

Moving the Cooker

n

On no account try and move the cooker while it is 

plugged into the electricity supply.

n

The cooker is very heavy, so take great care.

We recommend two people manoeuvre the cooker. Make 

sure that the floor covering is firmly fixed, or removed to 

prevent it being disturbed when moving the cooker around. 

To help you, there are two levelling rollers at the back and 

two screw-down levelling feet at the front. 
Remove the polystyrene base pack. From the front, tilt 

the cooker backwards and remove the front half of the 

polystyrene base (

Fig. 8.4

). Repeat from the back and remove 

the rear half of the polystyrene base.

Fig. 8.1

Fig. 8.2

Fig. 8.3

Fig. 8.4