2
n
The cooker MUST NOT be connected to
an ordinary domestic power point.
Access to the mains terminal is gained by
removing the electrical terminal cover box on
the back panel. Connect the mains cable to the
correct terminals for your electrical supply type
(
). Check that the links are
correctly fitted and that the terminal screws are
tight. Secure the mains cable using the cable
clamp.
Minimum temperature rating T105
Read the instructions before installing or using
this appliance.
•
This appliance is heavy so take care when
moving it.
•
The cable size and type should be suitable
for the Electrical Load of the appliance and
comply with the relevant national and local
requirements.
•
The cooker may be installed in a kitchen/
kitchen diner but
NOT
in a room
containing a bath or shower.
•
The cooker
MUST NOT
be connected to an
ordinary domestic power point.
•
It is normal for the hob control display
to flash for about 2 seconds during first
power setting.
•
Set the clock to make sure that the oven is
functional – see the relevant section in this
manual.
•
The appliance must be installed in
accordance with the regulations in force
and only in a well ventilated space.
•
Failure to install the appliance correctly
could invalidate any warranty or liability
claims and lead to prosecution.
•
DO NOT
install the appliance on a
platform.
•
DO NOT
manouvre the cooker while it is
plugged into the electricity supply.
ArtNo.130-0010 Electrical connections single-phase
L
N
230 V ac 50 Hz
10 mm² max
6 mm² max
L1
N
L3
L2
3N ac
230/400 V 50 Hz
6 mm² max
10 mm² max
6 mm² max
Fig. 1.1
Fig. 1.2
Summary of Contents for Longstock 90
Page 1: ...Longstock 90 Induction U110999 01a USER GUIDE INSTALLATION INSTRUCTIONS ...
Page 4: ...ii ...
Page 41: ...37 NOTES ...
Page 42: ...38 NOTES ...