Rangemaster Professional 90 Gas FSD, User Manual

18

A  electrode notch   

B 

ignition electrode

Now fit the two trim rings, making sure that they are 

sitting down properly.

Griddle

Always clean the griddle after use. Allow to cool 

completely before removing. Immerse the griddle 

plate in hot soapy water. Use a soft cloth or, for 

stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS 

AS THESE WILL DAMAGE THE SURFACE.

Control  Panel  and  Doors

The control panel and control knobs should only be 

cleaned with a soft cloth wrung out in clean hot soapy 

water - 

but take care that no surplus water seeps 

into the appliance.

 Wipe with a clean dampened 

cloth then polish with a dry cloth. The oven doors 

should only be cleaned with a soft cloth wrung out in 

clean hot soapy water.

Cookers  with  window  doors

On some models the oven door front panel can be 

taken off so that the glass panels can be cleaned. If 

the top edge of the oven door of your cooker has a 

line of holes and there are screws in the side edges 

then it can be taken apart for cleaning.
Move the cooker forward to gain access to the 

sides (see the ‘Moving the cooker’ section of these 

instructions). 
Open the oven door slightly and remove the front 

panel fixing screws from the door sides (two each 

side). 

some window doors only

Carefully lift off the outer door panel. The inside face 

of the glass panels can now be cleaned - take care 

not to disturb or wet the door insulation. Please note 

that the door is triple glazed but the inner two panels 

are fixed and should not be separated. After cleaning 

carefully refit the outer door panel and replace the 

side fixing screws.

Grill

The face of the grill burner will darken with use - this 

is perfectly normal. Any fat or grease will burn off. Do 

not try to clean it - the small holes could get blocked 

and affect burner performance.
The grill pan and grid should be washed in hot soapy 

water. After grilling meats or any foods that soil, leave 

to soak for a few minutes in the sink immediately 

after use. Stubborn particles may be removed from 

the grid by using a nylon brush.

The  Ovens

The  Main  oven

Cleaning is easier if carried out while the oven is still 

warm. Before cleaning, cover the burner to prevent 

the burner holes becoming blocked.
The inside of the oven and inner door panel can 

be cleaned using any cleaner approved for use 

on enamelled surfaces. Follow the manufactures 

instructions.
Take care not to disturb the oven thermostat 

temperature sensor at the top of the oven opening.

The enamelled oven burner trim (supplied with some 

models only) can be removed for cleaning.

The oven burner trim hooks onto the front of the oven 

burner bracket.

When refitting make sure that the trim is in the middle 

of the front of the oven burner bracket.