Rangemaster Professional+ 90 Gas, Installation And User Manual

15

ArtNo.331-0001Grill pan pulled forwards

ArtNo.331-0003 Grill frame out, no pan

ArtNo.331-0004 Removing the grill frame 

ArtNo.331-0005 Removing the grill rail

ArtNo.331-0006 Grill pan plan

Fig.5-5

Fig.5-6

Fig.5-7

Fig.5-8

Fig.5-9

Glide-out Grill

n

n

Before you remove any of the grill parts for cleaning. 

make sure that they are cool, or use oven gloves.

The face of the grill burner will darken with use – this is 

perfectly normal. Any fat or grease will burn off. Do not try to 

clean it – the small holes could get blocked and may affect 

the burner performance.
The grill pan and trivet should be washed in hot soapy water, 

alternatively, the grill pan can be washed in a dishwasher.
After grilling meats or any foods that soil, leave to soak for 

a few minutes in the sink immediately after use. Stubborn 

particles may be removed from the trivet by using a nylon 

brush.
The grill pan can be easily removed for cleaning as follows:
Remove the grill pan support frame by pulling the grill pan 

forward 

(Fig.5-5)

.

Lift the grill pan clear of the support frame.

The support frame 

is held to the side rails by two clips on each side 

(Fig.5-6)

.

For each side, support the side rail with one hand and with 

the other hand lift the frame up and out of the side clips 

(Fig.5-7)

.

For safety, push the side rails back into the grill chamber.
If you need to remove the side rails to allow cleaning of the 

grill chamber, you can unhook them from the grill chamber 

sides 

(Fig.5-8)

 and wipe the sides clean with a soft cloth and 

mild detergent.

DO NOT put the side runners in a dishwasher.

Once you have finished, hook the side rails back onto the 

sides of the chamber. To refit the frame, pull the side rails 

forward and, for each side in turn, support the side rail and 

press the frame down into the side rails. Replace the grill pan. 

When refitting the grill pan, make sure that the wide rim is at 

the front 

(Fig.5-9)

.

Control Panel and Doors

Avoid using any abrasive cleaners including cream cleaners. 

For best results, use a liquid detergent.
The same cleaner can be used on the doors or alternatively 

using a soft cloth wrung out in clean hot soapy water – but 

take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.