Rangemaster Professional+ 90 Gas, Installation And User Manual

16

Fig.5-14

Thermostat temperature sensor

ArtNo.323-0009 - Bray burner shield fitted

Oven burner trim

ArtNo.323-00011 - Bray burner front shield

Fig.5-11

Fig.5-12

Fig.5-13

Glass Fronted Door Panels

The oven door front panels can be taken off so that the glass 

panels can be cleaned. Move the cooker forward to gain 

access to the sides (see the 

‘Moving the Cooker’

 section under 

‘Installation’

).

Open the oven door slightly and remove the front panel 

fixing screws from the door sides, two each side 

(Fig.5-10)

.

Carefully lift off the outer door panel. The inside face of the 

glass panels can now be cleaned – take care not to disturb or 

wet the door insulation.

Note: 

If the door is triple glazed then the inner two panels are 

fixed together and should not be separated.
After cleaning, carefully refit the outer door panel and replace 

the side fixing screws.

n

n

DO NOT use harsh abrasive cleaners or sharp metal 

scrapers to clean the oven door glass since they can 

scratch the surface, which may result in shattering of 

the glass.

Ovens

Cleaning is easier if carried out while the oven is still warm. 

Before cleaning, cover the burner to prevent the burner holes 

becoming blocked. The inside of the oven and inner door 

panel can be cleaned using an approved cleaner 

(Table 5-1)

. 

Take care not to disturb the oven thermostat temperature 

sensor at the top of the oven opening 

(Fig.5-11)

.

The enamelled oven burner trim 

(Fig.5-12) 

can be removed 

for cleaning. The oven burner trim hooks onto the front of the 

oven burner bracket. When refitting make sure that the trim is 

in the middle of the front of the oven burner bracket  

(Fig.5-13)

.

‘Cook & Clean’ Panels

The main oven has panels which have been coated with a 

special enamel that partly cleans itself. This does not stop 

all marks on the lining, but helps to reduce the amount of 

manual cleaning needed.
The ‘Cook & Clean’ panels work better above gas mark 6 

(200 °C). If you do most of your cooking below this 

temperature, occasionally remove the panels and wipe with 

a lint free cloth and hot soapy water. The panels should then 

be dried and replaced and the oven heated at gas mark 6 

(200 °C) for about one hour. This will make sure that the ‘Cook 

& Clean’ panels are working effectively.

Do not use steel wool, oven cleaning pads, or any other 

materials that will scratch the surface.

Removing the Main Oven Linings

Some of the lining panels can be removed for cleaning. 
If you wish to clean the enamel interior of the oven, you 

will need to remove the shelves before removing the ‘Cook 

& Clean’ panels. You do not have to remove the support 

brackets to remove the panels. Lift each panel upward and 

slide forward off the support brackets 

(Fig.5-14)

.

Once the panels have been removed, the oven enamel 

interior can be cleaned. Refit in the reverse order.

ArtNo.320-0002a Proplus oven door side screws

Fig.5-10