Rangemaster Professional+ 90 Gas, Installation And User Manual

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

24

Levelling

You are recommended to use a spirit level on a shelf in one of 

the ovens to check for level.
Place the cooker in its intended position, taking care not to 

twist it within the gap between the kitchen units as damage 

may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the 

cooker.
To adjust the height of the rear of the cooker use a 13 mm 

spanner or socket wrench to turn the adjusting nuts at the 

front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.

Gas Connection

This must be in accordance with the relevant standards.
The flexible hose (not supplied with the cooker) must be 

in accordance with the relevant standards. Hoses may be 

purchased at most builders’ merchants.
The gas supply needs to terminate with a down-facing 

bayonet. The connector is located just below the hotplate 

level at the rear of the cooker. If in doubt contact your 

supplier.
The rear cover boxes limit the position of the supply point.
Because the height of the cooker can be adjusted and 

each connection is different, it is difficult to give precise 

dimensions.
Although a 900 mm hose can be used, a 1250 mm hose 

will allow slightly more flexibility in the positioning of the 

bayonet and make moving the cooker easier.
The hose should be fitted so that both inlet and outlet 

connections are vertical so that the hose hangs downwards in 

a ‘U’ shape. 
Ideally the hose supply connection should be within the 

shaded area ‘A’ 

(Fig.7-10)

.

For Natural Gas, the flexible hose must be in accordance with 

BS 669. For LP Gas, it should be capable of 50 mbar pressure, 

70 °C temperature rise, and carry a red stripe, band or label. If 

in doubt contact, your supplier. Screw connect the threaded 

end of the hose into the gas inlet.
After completing the gas connection, make sure that the 

cooker is gas sound with a pressure test.

ArtNo.090-0027 - 90 Elan gas connections 

300 

100 

240

A 

100

All dimensions in millimetres

Gas inlet

Fig.7-10