Rangemaster Professional+ 90 Gas, User'S Manual & Installation Instructions

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

23

ArtNo.000-0013 90 Door clearances

130 mm min

ArtNo.090-0009 - 90 2BC cooker min spacings

75 mm

min

75 mm

min

650 mm

min

905 mm min

930 mm max

Positioning the Cooker

Fig.7.1 

and

 Fig.7.2

 show the minimum recommended 

distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
The top of the hob surface should be level with, or above, any 

adjacent work surface.
A gap of 75 mm should be left between each side of the 

cooker 

ABOVE 

the hotplate level and any adjacent vertical 

surface.
For non-combustible surfaces (such as unpainted metal or 

ceramic tiles), this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of 

the hotplate and a horizontal combustible surface.

*Any cookerhood should be installed in accordance with the 

hood manufacturer’s instructions.
**Any splashback must be fitted in accordance with the 

manufacturers instructions. Allowance should be made for the 

additional height of the flue trim, which is fitted to the cooker 

hob. 

Surfaces of furniture and walls at the sides and rear of the 

appliance should be heat, splash and steam resistant. Certain 

types of vinyl or laminate kitchen furniture are particularly 

prone to heat damage and discolouration.
We cannot accept responsibility for damage caused by 

normal use of the cooker to any material that de-laminates 

or discolours at temperatures less than 65 °C above room 

temperature.
We recommend a gap of 910 mm between units to allow 

for moving the cooker. Do not box the cooker in – it must 

be possible to move the cooker in and out for cleaning and 

servicing.
If the cooker is near a corner of the kitchen, a clearance of 

130 mm is required to allow the oven doors to open 

(Fig.7.3)

. 

The actual opening of the doors is slightly less but this allows 

for some protection of your hand as you open the door.

Moving the Cooker

n

n

On no account try and move the cooker while it is 

plugged into the electricity supply.

n

n

The cooker is very heavy, so take great care.

We recommend that two people manoeuvre the cooker. 

Make sure that the floor covering is firmly fixed, or removed, 

to prevent it being disturbed when moving the cooker 

around.
To help you, there are two levelling rollers at the back, and 

two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt the 

cooker forward and remove the front half of the polystyrene 

base 

(Fig.7.4)

. Repeat from the back and remove the rear half 

of the polystyrene base.

ArtNo.090-0012 Min positions above cooker 

900 mm min*

**

5 mm

5 mm

410 mm min

Fig.7.1 

Fig.7.2 

Fig.7.3 

Fig.7.4