Rangemaster Professional+ 90 Gas, User'S Manual & Installation Instructions

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

26

Earth:

 to the 

terminal marked E, 

coloured Green/Yellow

Live: 

to the 

terminal marked L, 

coloured Brown

Neutral: 

to the

terminal marked N,

coloured Blue

Fig.7.11 

Pressure Testing

The gas pressure can be measured at one of the hotplate 

burner injectors (not the wok burner).
Lift off a burner head. Fit the pressure gauge to the injector. 

Turn on and light one of the other hotplate burners.
Turn on and press the control knob for the burner with the 

pressure gauge fitted to let gas through.

See the data badge for test pressures.

Turn off the burners. Make sure that you reassemble the 

burner top in the correct way on the burner body.

Electrical Connection

The cooker must be installed by a qualified electrician, in 

accordance with all relevant British Standards/Codes of 

Practice (in particular BS 7671), or with the relevant national 

and local regulations.

n

n

WARNING: THIS APPLIANCE MUST BE EARTHED.

All external wiring must comply with the IEE Regulations 

for the Electrical Equipment of Buildings. Connection to the 

electrical supply can be made with either a plug and socket 

or be permanently wired via a double pole switch. The cooker 

is supplied with a 3-core cable 2 m long. If a replacement 

cable is fitted it must be 250 V high temperature PVC (85 °C), 

1 mm².
Should the plug not fit the socket in your home, it should be 

removed and replaced with a suitable plug.

Note: 

If the plug is fitted is not suitable, it must be cut off and 

disposed of properly. To avoid the risk of electrocution, the 

plug must not be left where children might find it and plug it 

into a supply socket.
Three pin plugs to BS 1363 with a capacity of not less than 

13 A must be used and fitted with a 13 A fuse ‘ASTA’ approved 

to BS 1362.
You MUST refit the cover after replacing the fuse. If the cover 

is lost, the plug MUST NOT be used until a replacement cover 

has been obtained from your supplier. The colour of the 

correct fuse carrier is that of the coloured insert in the base of 

the fuse recess, or stated elsewhere on the plug. Always state 

this colour when ordering a replacement fuse carrier.

IMPORTANT: 

The wires in the mains lead are coloured in 

accordance with the following code 

(Fig.7.11)

:

Green and yellow: 

EARTH

Blue: NEUTRAL
Brown: LIVE