21
ArtNo.010-0004 Moving the cooker
ArtNo.000-0015 90 Fitting the stability bracket
A
����
C
D
�����
B
B
ArtNo.010-0010 Lowering the rear rollers (90)
x10
Fig.7-6
Fig.7-7
Fig.7-8
A - Wall face, B - Rear rollers, C - Front levelling feet,
D - Pencil datum line
ArtNo.010-0002 Rear roller nut
Fig.7-5
ArtNo.070-0005 - Stability bracket
�
�
Fig.7-9
A - Back of cooker, B - Stability bracket
Lowering the Two Rear Rollers
First fit the levelling tool on the hexagonal adjusting nut
(Fig.7-5)
. Make 10 complete (360º) turns clockwise
(Fig.7-6)
.
(This means turning and removing the levelling tool 20
times).
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Completing the Move
Unfold the rear edge of the pack base tray. Open the grill
door and right-hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the oven
(Fig.7-7)
.
Carefully push the cooker backwards off the pack base.
Remove the pack base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
Do not use the door handles or control knobs to
manoeuvre the cooker.
Fitting a Stability Bracket
A stability bracket or chain (not supplied by with the cooker)
should be fitted when the cooker is connected to a flexible
gas supply.
When fitting a stability bracket, read these instructions
together with the leaflet supplied with the bracket.
1.
Place the cooker in its intended position and level the
cooker.
2.
Draw a pencil line 70mm from the front edge of the
levelling feet.
3.
Mark the centre line for the bracket by measuring
550mm from the left-hand side of the cooker.
4.
Move the cooker forward.
5.
Measure back from the pencil line 500mm to locate the
front edge of the bracket
(Fig.7-8)
.
Position the bracket so that it is away from centreline of
the cooker to reduce the possibility that it will trap the
electrical connection cable or gas hose.
Fix the bracket to the floor.
6.
Measure the height from floor level to engagement
edge in back of cooker. Add 3mm to this dimension and
assemble the stability bracket to this height (i.e. from
floor level to underside of the top member), and ensure
the bracket does not foul the oven burner assembly
(Fig.7-9)
.
Repositioning the Cooker following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig.7-7)
, you need to check behind the cooker to ensure that
the gas hose is not caught.
Summary of Contents for Professional+
Page 30: ...28 ...
Page 31: ...29 ...
Page 32: ... www rangemaster co uk ArtNo 000 0003 CE logo DocNo 000 0001 Back cover Rangemaster ...