Rangemaster RBC38, Installation, Operation And Maintenance Instructions

12

CARE AND CLEANING OF YOUR BEVERAGE CENTRE

Condenser

The condenser underneath the cabinet does not require 
frequent cleaning; however, satisfactory cooling depends on 
adequate ventilation over this heat exchanger. It is recom-
mended to annually clean the condenser by vacuuming and 
brushing. To access the condenser, the unit must be pulled 
out from the installation, and the lower machine compart-
ment access cover removed. 

Disconnect the power cord before removing the access 
cover.

Be sure that nothing obstructs the required air flow openings 
in front of the cabinet.  At least once or twice a year, brush 
or vacuum lint and dirt from the front grille area 
(see page 3).

Cabinet

The painted cabinet can be washed with mild soap and 
water and thoroughly rinsed with clear water.  NEVER use 
abrasive scouring cleaners.

Interior

Wash interior compartment with mild soap and water.  Do 
NOT use an abrasive cleaner, solvent, polish cleaner, or 
undiluted detergent.

Pull-out Racks

The racks may be cleaned with mild soap and water and a 
soft cloth.  Do NOT use any abrasive cleaners.

Glass Door

Use a glass cleaner or mild soap and water and soft cloth 
to clean the glass door model.  Do NOT use any abrasive 
cleaners.

Door Gasket

The vinyl gasket may be cleaned with mild soap and water, 
a bicarbonate of soda solution, or a mild scouring powder.

Light Bulb Replacement

DISCONNECT THE POWER CORD BEFORE ATTEMPTING 
LIGHT BULB REPLACEMENT.  Failure to do so may result in 
an electrical shock that could severely injure you.

The RBC38 and RBC60 use one, 25 watt incandescent light 
bulb to illuminate the interior of the refrigerator.  The light 
bulb is a very reliable electrical component, but should it not 
function properly, please call the dealer where you pur-
chased your refrigerator from for a replacement light bulb.  
Use only an original equipment light bulb from your dealer 
or Rangemaster.

Do NOT under any circumstance use a light bulb that ex-
ceeds 25 watts!

To replace the light bulb, disconnect power to the unit.  Un-
screw the old light bulb located behind the display housing 
at the top of the unit.  Set the old light bulb aside.  Screw 
the new light bulb into place.  Reconnect power to the unit. 
Check to see if the light bulb operates properly to complete 
the installation.

The light bulb is not covered by your warranty.  A replace-
ment bulb can be obtained from your dealer or from Range-
master.

In the Event of a Power Failure

If a power failure occurs, try to correct it as soon as possible.  
Minimize the number of door openings while the power is 
off so as not to adversely affect the unit’s temperature.  

If a power interruption occurs, the unit may take 5 to 10 
minutes to restart.

NOTE