If your appliance has a moulded plug, you do
NOT have to do the following assembly as shown
in Figure 1. Appliances with moulded plugs are
ready to use as is.
Important:
The wires should be connected to the ter-
minals of the plug as follows:
Earth to the terminal marked E or coloured Green or
Green/Yellow.
Neutral to the terminal marked N or coloured Black or
Brown
Live to the terminal marked L, or coloured Red or Brown
When wiring the plug, ensure that all strands of wire
are retained in each terminal. The flexible mains
cable, plug and socket must not be exposed to flue
products or be allowed to come in contact with a hot
surface. The cable must not be trapped or pulled taut
when the appliance is pushed into position.
How to Operate Your
Refrigerated Wine Cooler
Set the Control:
The total available temperature
range of the unit is from 5°C to 17°C. The middle
range on the control is approximately 13°C. The tem-
perature can be lowered or
raised by turning the control
clockwise or counterclock-
wise, respectively. As with
any refrigeration product,
there is a slight temperature
variance at different loca-
tions within the cabinet. For example, the coolest bot-
tles will be in the middle shelves. The bottles on the
top two shelves will be 1°C to 2°C warmer. This is the
warmest location. The bottles in the front of the
shelves will be 1°C to 2°C warmer than the rear of the
shelves. Position your wine inventory accordingly. To
start your appliance, use a screwdriver to turn the
control clockwise to the middle thermostat setting
(see figure 2). Once the bottles are loaded, allow at
least 48 hours for the unit to stabilize before making
any adjustments to the initial setting.
We recommend you place a small thermometer
inside the wine cooler that is visible when looking
through the glass door. This will help you establish
the cabinet interior temperature you wish to store
your wine collection at.
Insert Wine Bottles:
The top two fixed-in-place racks
each hold six bottles, two deep with the necks alter-
nating front (rear bottles) to back (front bottles), See
figure 3. The middle four slide-out racks each hold
eight bottles, two deep with necks alternating front
(rear bottles) to back (front bottles). The bottom rack
holds six bottles that are loaded with necks facing the
rear. Tall bottles should not be loaded on the bottom
rack because they may prevent the door from closing.
3
Figure 2
Control Knob
Figure 3
Front Bottles (Necks Facing Rear)
Rear Bottles (Necks Facing Front)
Under Counter Wine Cooler Specifications
Dimensions W x H x D (mm)
606 x 864 x 616
Weight
59 kg
Capacity
50 Wine Bottles
Temperature
5-17°C
Power Supply
230V
supplied with a 13 amp plug
Green/Yellow
(earth)
Blue
(neutral)
Fuse (13A)
Brown
(live)
Plug in the mains cable and switch on the electricity supply.
Figure 1
