Rangemaster SxS 663, User Manual & Installation & Service Instructions

17

ArtNo.601-0010 - SxS 661-9 - Pipe to filter

Fig.4-12

Electrical Supply Connection

Connect the appliance to the electrical supply (220-240 V ~ 

50 Hz) with the plug and lead, which are fitted.
Connections to the mains supply should be in accordance 

with local regulations.

n

n

The appliance must be plugged into an earthed 

socket.

n

n

Always make sure that the plug is accessible after 

the appliance has been positioned.

Water Supply Connection

n

n

It is recommended to have this product installed by 

a qualified technician.

Note: For further installation details refer to the instructions 

supplied with the water filter.

• 

Pressure of the cold water supplied to the automatic 

icemaker is between 1.5-8.5 bar.

• 

The water tube should be of an appropriate length, 

usually 12 metres, and should be free of bends after 

being inserted into place. If the water pipe is too long 

then the water pressure will be reduced, affecting the 

ice and cold water content.

• 

DO NOT connect water supply when the ambient 

temperature is below 0 °C, otherwise the water pipe 

may freeze.

• 

Always use potable/drinking water.

• 

Keep the water tube clear of heat sources.

• 

The water filter is there to filter impurities in the water, 

and to make ice clean and hygienic. It cannot sterilise 

or destroy anything, so be certain to connect the water 

pipe to a drinkable water source.

Fitting the Water Filter

Measure out and cut the length of pipe required from the 

filter to the Fridge-freezer, and from the filter to the water 

supply. Make sure that you achieve a square cut using a sharp 

knife.
Push fit one of the pipes into the water filter (Fig.4-12).
Secure the pipe to the filter by sliding a locking clip into the 

groove as shown (Fig.4-13).
Repeat the procedure on the other end of the filter.
Connect the end into the plastic adaptor (Fig.4-14). Screw 

the adaptor onto a suitable ½” BSP connector water outlet.
Open the water valve to flush the pipe, check leakage in the 

water pipe joints and allow the water to run until it is clear.

Commissioning the Water Dispenser

Before first use, press the water dispenser pad several times 

for 1 minute. Do not press for more than 1 minute to prevent 

overheating of the pad activator solenoid. Cold water will 

begin to flow from the outlet.

ArtNo.601-0005 - SxS 661-9 - Securing the pipe

Fig.4-13

ArtNo.601-0014 - Pipe to BSP connector

Fig.4-14