36
Remove the element fi xings and withdraw element.
Replace the element and re-assemble parts in reverse
order.
Top Element
Open the oven door and undo the fi xings that secure the
heat shield. Remove the top element bracket fi xings and
withdraw element. Replace the element and re-assemble
parts in reverse order. Check that the oven operates
satisfactorily.
26. To change oven light bulb.
Turn off the power supply.
Make sure the oven is cool. Open the oven door and
remove the oven shelves.
Unscrew the bulb cover by turning anticlockwise. It may
be very stiff .
Taking care to protect your fi ngers in case the bulb should
shatter, unscrew the old bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Screw in the new bulb, screw back the bulb cover. Turn on
the electricity supply and check that the bulb now lights.
27 To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the angle
of the door.
Loosen the bottom hinge fi xing screws and use the notch
and a fl at bladed screwdriver to move the position of the
hinge to set the hinge position.
Retighten the hinge screws.
Eff ect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
Summary of Contents for U109300 - 01
Page 1: ...Classic Deluxe 90 Dual Fuel Users Guide Installation Service Instructions U109300 01...
Page 39: ......
Page 40: ...070606...
