Rangemaster U110120 - 01A, Installation And User Manual

8

Cover caps

Cabinet hinge screws

Procedure

1. 

Loosen the cabinet hinge screws and carefully slide 

the door off 

(fig.4-2)

. To stop the door from being 

damaged, place it on a cushioned surface.

2. 

Lever off the cover caps on the left-hand side of the 

appliance cabinet 

(fig.4-3)

. 

3. 

Remove the door hinge screws and refit to the left-

hand side of the cabinet. These screws should only be 

partially tightened.

4. 

Undo the door hinge screws and remove the hinges.

5. 

Reverse the position of the top and bottom hinges 

and fit them to the left-hand side of the door 

(fig.4-4)

. 

Secure in place using the door hinge screws.

6. 

Slide the door onto cabinet hinge screws. Tighten the 

screws to secure.

7. 

Insert the cover caps into the holes on the right-hand 

side of the cabinet.

IMPortant:

 After you have completed reversing the door, 

check that the door opens and shuts correctly without 

fouling. 

You should also check the door seal of the appliance. The seal 

should not be creased or crushed; otherwise there will be a 

gap between it and the inside of the door.
The seal must adhere properly all the way around the door.
If the seal is not adhering to the cabinet properly, then you 

should either:

A. 

Use a warm damp cloth and manipulate the seal until it 

does adhere to the cabinet properly, all the way around 

the door, or

B. 

Use a hair dryer on its lowest heat setting and lightly 

heat the areas of the door seal that are not adhering 

correctly. The heat will make the seal more pliable 

and this will allow you to manipulate the seal into the 

correct position.

IMPortant: 

DO NOT heat the door seal on anything but 

the lowest heat setting or heat the seal for a long period 

of time, otherwise you may damage the door seal, which 

would NOT be repaired under the guarantee free of charge.

The appliance must be stood on a level floor. You can use the 

levelling feet to take into account any minor unevenness in 

the floor.

fig.4-3

fig.4-2

fig.4-4