For technical support, contact us at 1-800-565-5321
6255 Installation Guide
| REV. A1 | Page
3
PHASE 1
– PREPARATION
1.1 REMOVING
PHASE 2
– INSTALLATION
2.1 SEAT COVER INSTALLATION
q
1.1
Remove Headrests.
q
Pull headrests out of the seats
by pressing the tabs at the base of the headreasts
.
q
2.1
Install Seat Back Cover.
q
Ensure the tag inside the cover corresponds with the seat you are working on.
Each cover will have a Driver or Passenger tag.
q
Undo elastic strap holding seat back flap from under seat bottom (Black strap with white clip).
q
Tip seat back flap up and tuck inside seat cover as you pull it down.
q
Turn seat cover 3/4 of the way inside out.
q
Pull seat back cover into position, making sure that the holes in the cover align
with the holes in the seat back.
q
Stretch the cover over the headrest holes.
q
Continue pulling the cover down the seat back, turning it right side out as you go.
q
Push flap from front of cover between seat back and seat bottom, out the back of the seat .
q
Double the end of the flap over to prevent the “hook” Velcro
from sticking to the factory upholstery.
q
Pull the flap tight and attach to the Velcro on the back of the seat.
q
Fasten flap under the armrest.