31
SECTION 17
MAINTENANCE INSTRUCTIONS
Read and follow all the maintenance instructions provided
in this manual to keep the machine in good operating
condition. Regular inspections and proper maintenance
are essential to preventing accidents and injuries. These
instructions will help you service the unit. Instructions are
for a person with some mechanical ability and training. No
attempt has been made to describe all basic steps like how
to loosen or tighten fasteners. Basic procedures such as
cycling systems and checking operation of the equipment
are not fully described. Do not attempt to perform work
beyond your ability or at which you have no experience. If
you need assistance, call an authorized service center or
contact the factory.
DAILY
t
Check the tire pressure gauge function daily, and check
the accuracy monthly. Use a pressurized tire and a high
quality pressure gauge. If the gauge is defective, replace it
immediately.
t
Make sure all fasteners are securely tightened and all
guards and covers are in place.
t
Check for worn, damaged or missing parts including
grips and protective covers. Replace them before allowing
the unit to be used.
MONTHLY
t
The vertical and horizontal slides and the helper slides
should be cleaned with a vaporizing solvent and then
lubricated with chassis grease once a month.
(See Fig. 17.1)
t
Check adjustment of the mount/demount head
monthly.
t
Check function of the inflation hose pressure
limiter/regulator monthly. Always secure/stow the cover if
adjustments are made.
The pressure regulator should
never be adjusted to exceed 60 PSI.
t
The table top, clamps, steel mount/demount head, and
other working surfaces should be cleaned with a vaporizing
solvent every month.
t
On a daily basis, inspect the unit and check to be
certain that all systems are operating normally. Follow
detailed inspection and testing procedures as specified for
various components at regular intervals.
t
Replace any damaged or missing safety decal’s. They
are available from the factory.
Mount/Demount Tool Head Adjustment
To adjust tool head lift, adjust locking nut up or down until
lift clearance is 1/8” to 3/16”. Recheck clearance before
replacing cover. (See Fig. 17.2 - 17.3)
Fig. 17.1
Fig. 17.2
Fig. 17.3
