SPECIFICATIONS / FEATURES
PROFESSIONAL:
Models: R7580H-601 / R7580H-603 / R7580V-601 / R7580V-603
Motor
Max
PSI/BAR
Max CFM
@ 90
PSI/LM
Max CFM
@ 175
PSI/LM
Standard Voltage*
Pump Design
Speed
(RPM)
Tank
7.5hp
5.5 KW
175 PSI
12 BAR
26.5 CFM
750LM
25.5 CFM
723 LM
208-230V / 60 Hz
1 Phase
Tri-max™
3 Cylinder / 2 -Stage
1,150rpm
80 Gal.
304 L
Centrifugal unloader for no-load start
Mag Starter
Hardened steel disc valves
Precision balanced fan-type flywheel
Oversized tapered roller bearings
Forged ductile iron crankshaft
Forged aluminum alloy piston
Forged aluminum alloy connecting rods
Cast iron cylinders with deep-cool fins
Forced air aftercooler
Oil sight gauge
Totally enclosed belt guard
Forced air cooling
Pressure switch
Overload pressure safety valve
Pressure gauge and dual service valves
Oversize replaceable air filters
Auto start / stop
Model
Dimentions
Ship
Weight
R7580H-601
L 76" x H 44-1/2" x W 34-1/2"
L 1930mm x H 1130mm x W 876mm
650 Lbs
295 Kg
R7580V-601
L 37" x H 73" x W 34-1/2"
L 1930mm x H 1130mm x W 876mm
658 Lbs
298 Kg
* 3 phase and 50hz models are available upon request.
The standard features
ASSEMBLY INSTRUCTION
There is no assembly required. This compressor is completely pre-assembled at the factory.
Installation and Location:
Locate the compressor in a clean, dry and well ventilated area. The compressor should be located 12” to 18” from a
wall or any other obstruction that would interfere with the air flow through the fanbladed belt-wheel. Place the com-
pressor on a firm, level surface. The compressor is designed with heat dissipation fins which allow for proper cooling.
Keep the fins and other parts that collect dust and dirt clean. A clean compressor runs cooler and provides longer ser-
vice. Do not place rags, containers or other materials on top of the compressor which would obstruct ventilation open-
ings for proper compressor operating temperature.
For Vertical Type Only:
For permanent installation, the compressor should be bolted to the floor through holes pro-
vided in the compressor feet. Shims must be used to level the compressor before bolting it to the floor. Severe vibra-
tion will result when the compressor is bolted down tightly and the feet are not level. This can lead to welds cracking
or fatigue failure of the air receiver.
