INSTALLATION INSTRUCTIONS
Location
Select a location that will provide the operator with enough
space to use the equipment in a safe manner. The area
selected should be well lit, easy to clean and should be
away from oil, grease, etc. Avoid areas where bystanders
and customers may be present.
Electrical Source
This unit requires power from a 15 amp electrical circuit.
Refer to the serial tag of the machine for specific electrical
requirements. Have a licensed electrical technician perform
any necessary changes to the power source before plugging
in the unit. The electrical source must have a solid
connection between ground and building ground.
MAINTENANCE INSTRUCTIONS
Read and follow all the maintenance instructions provided
in this manual to keep the lathe in good operating
condition. Regular inspections and proper maintenance
are essential to preventing accidents and injuries. These
instructions will help you service the unit. Instructions are
for a person with some mechanical ability and training. No
attempt has been made to describe all basic steps like
how to loosen or tighten fasteners. Basic procedures such
as cycling systems and checking operation of the equip-
ment are not fully described since they are described in
this manual. Do not attempt to perform work beyond your
ability or at which you have no experience. If you need
assistance, call an authorized service center or contact
the factory.
PREVENTIVE MAINTENANCE
Check for worn, damaged or missing parts including
grips and protective covers. Replace them before allowing
the unit to be used.
Make sure all fasteners are securely tightened and all
guards and covers are in place.
Replace any damaged or missing safety decal’s. They
are available from the factory.
On a daily basis, inspect the unit and check to be
certain that all systems are operating normally. Follow
detailed inspection and testing procedures for various
components at regular intervals.
GENERAL LUBRICATION
Oil the ways of the head assembly and thread screw
periodically with a light oil. Note: Cross feed should be in
full inward position during lubrication.
Oil the threaded rods periodically with a light oil. Spray
the drum lead screw with silicone lubricant.
Lightly oil the dovetails with motor oil.
CLEANING
Keep the lathe as clean as possible for trouble free
operation as well as safety and longer lathe life. Use a
brush to sweep metal chips and dust off the lathe.
After use, always wipe clean.
Clean all exposed metal parts with a brush and apply
a light coating of motor oil with. Note: DO NOT apply oil to
the tool slide clamping surface or the round tool holders on
the twin cutter.
Use only Ranger original or authorized service
parts to insure safety and performance.
18
Before making any inspection, adjustment, or
repair, disconnect the power source and block out all
moving parts to prevent injury.
Keep the machine and the immediate work area
clean. Do not use compressed air to remove dirt and
debris from the lathe. Chips and dust may be driven
between machined parts and into bearings causing
undue wear and foreign material may be propelled
into the air and into operator or bystander causing
personal injury.
Wear protective clothing and use eye protection
when making any adjustments or repairs to the
machine.
Proper unit installation is necessary for safe use
and efficient operation. Proper installation also
helps protect the unit from damage and makes
service easier. Always keep this manual nearby.
