15
1. Check the voltage, phase and proper amperage requirements for the motor shown on the motor plate.
Wiring should be performed by a certified electrician only.
2. Overheating, short circuits and fire damage will result from inadequate wiring. Wiring must be installed in accordance
with National Electric Code and local codes and standards covering electrical apparatus and wiring.
3. Be certain that adequate wire sizes are used, and that:
t
Service is of adequate amp rating.
t
The supply line has the same electrical characteristics (voltage, cycles and phase) as the motor.
t
The line wire is the proper size and that no other equipment is operated from the same line.
Check the voltage, phase and proper amperage requirements for the motor shown on the motor plate.
Wiring should be performed by a certified electrician only.
STANDARD WIRING IS 208-230V 60HZ / Single Phase
Fig. 8.1
Fig. 8.2
Refer to Page 9 Item # 27 for location of On / Off Switch
WIRING INSTRUCTIONS
Summary of Contents for RX3040
