22
IN AND OUT- AUTO LOCATING- TARGET LOCK™
Exclusive to the Ranger RX3040 is the Target Lock™
feature. Once the Position of the Bead Breaker Rollers
are located in relation to the Rim edge.
1. Push and hold the center button of the Tool Head
Control Joystick. (See Fig. 9.21)
2. The Tool Head Assembly will extend and stop
automatically within 1/8’ inch of the rim edge.
(See Fig. 9.22)
HOOK OR TAB POSITION
The orientation of the Tool Head can be changed to
select either the Hook or Tab end up. Hook end is used
for Upper tire Bead.
1. To change the orientation of the Toll Head Depress
the Tool Head Control Pedal and release. (See Fig. 9.23)
2. Each time the Tool Head Control Pedal is depressed
the Tool Head will rotate. (See Fig. 9.24 & 9.25)
CAUTION!
ANY TIME THE TOOL HEAD IS CHANGED FROM
THE STEEL HEAD TO PLASTIC OR VICE VERSA,
THE STOP POSITION OF THE TOOL HEAD MUST
BE ADJUSTED. SEE PAGE 54 FOR DETAILS
CAUTION!
ENSURE THE TOOL HEAD IS RETRACTED TO
PROVIDE ENOUGH CLEARANCE TO ALLOW THE
TOOL HEAD TO ROTATE FREELY OR DAMAGE
TO THE TIRE CHANGER, RIM AND OR TIRE MAY
OCCUR.
NOTE:
THE TOOL HEAD IS ADJUSTED FROM THE
FACTORY SO THAT HE TAB SIDE OF THE TOOL
HEAD WILL BE 1/8” FROM THE RIM EDGE WHEN
PUSHING AND HOLDING THE TARGET LOCK™
BUTTON ON THE TOOL HEAD JOYSTICK
CONTROL. THE HOOK SIDE WILL BE SLIGHTLY
FARTHER AWAY FROM THE RIM EDGE.
Fig. 9.21
Fig. 9.22
Fig. 9.23
Fig. 9.24
Fig. 9.25
Summary of Contents for RX3040
