33
SECTION 11
DEMOUNTING A TIRE
1. Roll the tire onto the Wheel Lift. (See Fig. 11.1)
2. Press the Lift Pedal to raise the tire up to full height.
(See Fig. 11.2)
3. Move to the left side of the Tire Changer and flip the
Tire onto the turntable Lift. (See Fig. 11.3)
4. Center the tire rim over Turntable post.
5. Press the Wheel Lift Pedal again to lower the rim
onto Turntable.
6. Align a lug hole on the rim towards the front of the
machine (at 6 o’clock position). Slowly lower the Tire so
that the Alignment Pin goes into a lug hole on the rim.
(See Fig. 11.4)
7. Select an appropriate Centering Cone for the hub
hole. Slide Cone down Post. (See Fig. 11.5)
CAUTION!
ALWAYS STEADY THE TIRE DURING ANY LIFTING
OR LOWERING OPERATION TO PREVENT THE
TIRE FROM FALLING OFF THE WHEEL LIFT
.
Fig. 11.2
Fig. 11.3
Fig. 11.1
Fig. 11.4
Fig. 11.5
Summary of Contents for RX3040
