51
STAGE FOUR / TIRE INFLATION
1. Make sure both beads are seated. When both beads are
seated, the tire is ready for inflation.
2. Replace the valve core if it was removed.
3. Depress the inflation pedal to inflate the tire.
DO NOT STAND OVER TIRE DURING INFLATION.
4. Do not inflate the tire above the manufacturer’s
recommended pressure as stamped on the tire sidewall.
The typical inflation pressure for automobile tires is between
24 and 45 PSI. Light truck inflation pressure typically covers
a wider range. Release air pressure from the tire by
pressing the manual release valve button.
DANGER!
IMPORTANT!
WHEN INFLATING TIRES THAT REQUIRE MORE
THAN 60 PSI, ALWAYS USE A SAFETY CAGE
AND AIR HOSE WITH A CLIP-ON CHUCK AND IN
LINE VALVE. THE HOSE MUST HAVE ENOUGH
LENGTH BETWEEN THE CHUCK AND THE
OPERATION/IN-LINE VALVE TO ALLOW THE
OPERATOR TO OUTSIDE THE TRAJECTORY.
WARNING!
THE INFLATION PRESSURE LIMITER IS
PRE-SET AT THE FACTORY AND SHOULD NEED
NO ADJUSTMENT. ADJUST ONLY IF PRESSURE
EXCEEDS 60 PSI.
OPERATING A TIRE CHANGER WITH A DEFECTIVE,
IMPROPERLY ADJUSTED, OR BY-PASSED
PRESSURE LIMITER COULD RESULT IN A TIRE
EXPLOSION WITH SEVERE INJURY OR DEATH TO
THE OPERATOR OR BYSTANDERS.
ALWAYS BE SURE THAT THE PRESSURE LIMITER
IS OPERATING PROPERLY ON THE MACHINE AT
ALL TIMES. PRESSURE LIMITER IS SET AT 60 PSI.
ANY REQUIRED INFLATION ABOVE 60 PSI SHOULD
BE PERFORMED IN AN INFLATION CHAMBER/
SAFETY CAGE. A TIRE EXPLOSION MAY CAUSE
PERSONAL INJURY OR DEATH TO OPERATOR OR
BYSTANDERS.
Fig. 16.3
Summary of Contents for RX3040
