QUICK START SETUP GUIDE- Demounting
1. The Centering Cone must make contact with the Hub
Hole Edge.
2. You
MUST
use the Turntable Spacer when the Hub
Hole of the Rim requires use of either of the Large Cen-
tering Cones.
3. Use of the Large Centering Cone without the Spacer
will prevent proper wheel mounting.
Setting the Bead Breaker Roller
and “Target Lock” Distance.
1. Set the distance from the Rim edge to the Bead
Breaker Roller to 1/8’.
2. Once this distance is set. DO NOT move the
Turntable. When you press the “Target Lock” Button for
the Bead Hook / Tab Arm, the Hook/Tab Arm will extend
and stop the same distance from the Rim that was set
with the Bead Breaker Roller.
3. ALWAYS liberally lube both Upper and Lower Beads,
then Hook Upper Bead as Shown.
REFER TO THE COMPLETE SAFETY, INSTALLATION AND OPERATION MANUAL IF YOU ARE UNSURE OF ANY
TIRE MOUNTING OR DEMOUNTING PROCEDURES OR HAVE NOT USED THIS STYLE OF TIRE CHANGER.
IMPORTANT! FOLLOW THIS SET UP GUIDE PRIOR
TO USING THE MACHINE OR DAMAGE TO THE
TIRE CHANGER OR RIM & TIRE MAY OCCUR!
