7
4. Slide the Hood Arm over the Hood Axle, align the holes in
the Axle with the Allen bolts then secure in place using the
two allen set screws.
5. Raise the hood and hold it up. Use help to hold the hood
while attaching the hood to the Hood Arm.
6. Slide the Hood Pin into the hole on the end of the hood
arm and align the holes with the allen bolts and secure in
place using the two allen set screws.
7. Connect the hood switch wires as shown.
8. Tuck the wire into the Hood Switch Box and install Hood
Switch Box Cover an tighten allen bolts
INSTALLING THE
THREADED MAIN SHAFT
1. Locate the Face Plate / Threaded Main Shaft and
mounting bolt in the accessory box and install as shown.
2. Locate and align the witness marks on the Face Plate
and Shaft Assembly.
3. Be sure to tighten the bolt firmly. Step on the manual
brake to hold the shaft while tightening the bolt.
INITIAL START-UP
1. Turn the balancer ON/OFF switch to ON.
2. The LED Display will show USA 511.
3. Press START button. The threaded main shaft should
spin CLOCKWISE when viewed straight on. If the faceplate
spins counterclockwise, turn the balancer off and consult
the factory.
4. Now lower the Hood to check the activation of the AUTO-
HOOD START. The Main shaft should spin when the hood
is lowered.
5. To enable/ disable AUTO HOOD START feature press
and hold the STOP Button and the R button.
