17
wHEEL CLAMP ADJuSTMENTS
1. Place the Wheel Protector pads on the Wheel Clamps if
desired when clamping from the outside. (See Fig 11.6)
2. Place tire/wheel assembly on Table Top with mounting
side up. (See Fig 11.7)
3. Use the Wheel Clamp Foot Pedal to move the Clamps
inward (pedal down) or outward (pedal up). (See Fig 11.8 -
11.9)
DEMOuNTINg
1. Apply tire manufacturer’s approved rubber lubricant liber-
ally to entire circumference of
both upper and lower beads
after loosening bead and placing on table top. (See Fig
11.10)
2. After the wheel is secured to the Turntable, swing the
Vertical Arm into position. Use the large adjusting Knob to
position the Mount/Demount Head directly over the edge of
the rim. (See Fig 11.11)
3. Push the Vertical Shaft down and position the Mount/
Demount Head into contact with the rim edge and adjust as
necessary. (See Fig. 11.12 - 11.13)
NOTE:
CLAMP STEEL WHEELS FROM THE INSIDE (CLAMPS
PUSH OUTWARD AGAINST WHEEL). CLAMP MAG
AND CUSTOM WHEELS FROM THE OUTSIDE
(CLAMPS PUSH INWARD AGAINST THE OUTSIDE
RIM EDGE). REFER TO SECTION 12: CUSTOM AND
SPECIAL WHEELS.
Fig 11.6
Fig 11.7
Fig. 11.8
Fig 11.9
Fig 11.10
Fig 11.11
wARNINg!
THE RIM AND BEAD MUST BE LIBERALLY
LUBRICATED. FAILURE TO USE AN ADEqUATE
LUBRICANT CAN LEAD TO THE BEAD BINDING ON
THE RIM AND DAMAGE TO THE MOTOR AND OR
VOID THE WARRANTY.
Summary of Contents for R30XLT
