RML-600XL ATV / Motorcycle Lift
17
P/N 5900381 — Rev. D — June 2019
Normal Operation
The Platform is raised and lowered using the Air Pump.
⚠
WARNING
Avoid off-center and unbalanced loads. If the Lift seems to be having difficulty
raising a Vehicle, stop operation, lower the Platform back down to the ground,
check everything out, make any necessary adjustments, then try again.
To raise a Vehicle
:
1.
Make sure the Platform is fully lowered and the area around the Lift is clear of any obstructions.
2.
If you are raising an ATV, make sure the Side Extensions and the Side Extension Ramps are
installed and working properly.
3.
Open the Clamp wide enough to accommodate the front tire of the Vehicle you are about to
move onto the Platform.
4.
Push
a Vehicle onto the Platform;
do not drive
the Vehicle onto the Platform.
5.
Make sure the Vehicle is centered and balanced on the Platform.
6.
Close the Clamp to secure the front wheel.
7.
Use additional restraints to secure the Vehicle on the Platform, as needed.
8.
Check above and around the Vehicle on the Platform to make sure there is enough room to
safely raise the Vehicle. Only the technician should be within 30 feet while the Lift is in use.
⚠
WARNING
Do not raise a Vehicle until you are sure all components are in place and working
normally. If you raise a Vehicle without making a safety check first, you endanger
yourself and anyone else nearby and you risk damage to the Vehicle and the Lift.
9.
Stand away from the Lift, then use the Raise End of the Air Pump to raise the Platform.
10.
Go past the desired height, then stop raising the Platform.
11.
Make sure the Safety Lock Release Handle is hanging freely, not latched.
12.
Use the Lower End of the Air Pump to back the Safety Lock Release Handle down onto the most
recently passed Safety Lock.
13.
When the Platform stops moving, hold the Lower End of the Air Pump down for a couple more
seconds, then make sure the Safety Lock Release Handle is engaged on the same Safety Locks
on both sides.
