RP-20FC Oil Filter Crusher
13
P/N 5900011 — Rev. B1 — February 2021
Do not get distracted when removing a crushed filter. Be very careful not to
scratch, cut, or puncture your skin on the sharp edges of the crushed filter.
Watch for leaking oil.
7.
Place the Control Handle in “Off” (middle) position when the unit is not in use.
⚠
WARNING
Do not leave the Press Ram in the loaded position (pressed down). Once the Oil
Filter has been crushed, immediately retract the Press Ram, and then switch the
Control Handle to the “Off” position
Maintenance
⚠
WARNING:
Disconnect the unit from its power source
before performing any
maintenance!
To maintain your oil filter crusher
:
•
Make sure to keep the press clean and free of debris and dirt.
•
All exposed machine surfaces of the press should be brushed clean and wiped with a lubricant,
such as WD-40
®
for example, on a regular basis.
•
Regularly check the air lubricator and water filter for water and drain as needed.
•
Regularly clean the press chamber to remove any accumulated sludge, metal particles, or other
debris that could affect operation.
•
Keep the oil drain (on underside of reservoir base) free of accumulation of debris; remove any
materials that may be clogging the oil drain.
•
Inspect for leaks and drain the approved waste oil container in accordance with all local, state, and
federal regulations.
•
Lubricate the sliding door on a regular basis to prevent the door from binding.
Troubleshooting
Issue
Action to Take
Press ram does not move when
turned to the On position.
Check the Air Line connections.
Cycle stops before completing.
Check to see if the item being crushed is stuck; if so, remove
the item and start again.
Check to see if the item being crushed is off center. If so,
balance the load and start again.
If you continue to have issues with your Oil Filter Crusher, visit
, email us at
, or call
(805) 933-9970
.
Summary of Contents for RP-20FC
