Bringing the cameras together
For the work of the scanner it is necessary to point both cameras to the same position
on the specified working distance. Install the calibration plate in front of the scanner on
the found working distance (if you changed its position after the
projector focusing procedure.
Turn on the
Cross
light mode and aim the scanner to the calibration plate. It is not
necessary to combine cross with marks on the plate at this stage, the focused projector
should be projecting a cross on any surface, located at the working distance from the
scanner.
Install the cameras in position, corresponding to selected scan area. To do this, unscrew
the mounting screws, move the camera to the desired position, and then put the screws
back.
Next, rotate the cameras so that the vertical line of the light cross lies approximately on
the central vertical blue line in the both camera views as shown below. After that,
securely tighten the screws.
19
Summary of Contents for PRO
Page 1: ...RANGEVISION Setup and calibration PRO...
Page 31: ...RangeVision 2020 31...
