22
Adjusting the exposure and brightness
After you place an object at the needed distance, switch the projector to the
Lines
and Stripes
lighting mode. Adjusting exposure of the cameras (the slider in the toolbar),
get maximum exposure value, which does not cause red dots to appear on the lines.
Areas of the image, not relating to the scanned object, don't matter. Red color mark the
areas of the excess lighting. The scanner doesn't digitize such areas.
When working on battery, the brightness of illumination is lowered. Projector with
fully charged battery may work about an hour without being connected to a power
supply.
Due to close distance to an object, it may be necessary to lower the brightness of
lines and stripes in the menu
Brightness settings.
Set the brightness of lines at
approximately 2 times greater than the one of the stripes. Visually lines and stripes
must be the same brightness. Also you may lower the brightness of the projector itself.
Viewing the model
To see the whole preview model you can rotate,
zoom and pan the 3D view. For the convenience of
scanning, you can switch the display mode: only
images from the cameras, only 3D model or an image
and model together.
