24
Scanning without markers
When scanning without markers, the fragments of the model surface may not be
oriented in relation to each other, which decreases the scanning speed and the process
of gaining a 3D-model.
This scanning method may be used if the surface of the object has expressed
assymetrical relief, which will later serve as basis for fragments registering.
Sequence of actions when scanning without markers:
Prepare the surface of the object to be scanned (if needed)
Create new project without markers or open an existing one
Perform Orientation to check calibration of the scanner
Install object in front of the scanner at a working distance
Turn on Stripes and lines mode, check the sharpness of the projector and with
the help of the slider adjust the exposure of cameras
Start scanning with the corresponding button
Aim the scanner at the object at a different angle to obtain the next segment
Scan the object from desired sides, controlling the quality of obtained scans in
the 3D model viewing area.
After the end of scanning Go to SсаnMerge for processing of obtained data
The example of obtained data when scanning without markers:
