26
If a project can not cover all necessary areas to scan without moving the object
relative to the surface with markers, you need to create multiple projects (by number of
positions of the object relative to the markers) and then during the processing load
them together to combine.
Markers should be attached as chaotic as possible. Avoid expressed patterns or
curves, as this may provoke incorrect detection of markers. If the new fragment is not
correctly oriented in relation to the model, delete it to create a next scan. When using
auxiliary surface, object should not move in relation to the markers during the scan!
If there are not enough markers on the new scan (less than three) or the software is
unable to joint scan to already existing ones, an error message is sent and the scan is
considered to be unsuccessful. Also, an error may occur if the scanner was
decalibrated and can not properly assess the size of the markers.
Brightness of the projector light when identifying markers can be changed. Turn on
the illumination mode
Markers
and open the
Brightness settings
. Specify the
brightness value, at which the markers can be clearly seen on the output from the
cameras.
When creating project with markers, it is necessary to specify the type and size of
used markers. Scanner kit includes black markers with radius of 2.5 mm.
Sequence of actions when scanning with markers:
Stick markers on the object or auxiliary surface
Prepare the surface of the object to be scanned (if needed)
Create new project with markers or open an existing one
Perform
Orienting
to check calibration of the scanner
If the reference grid of 3D-marks is already created - load it through
File
Load
reference grid
