27
Set the object at a working distance from the scanner
Turn on
Stripes and lines
mode, check the sharpness of the projector and with
the help of the slider adjust the exposure of cameras
Start
scanning
with the corresponding button
Scan the object in the next position, visually observing the correctness of
fragments stitching in the 3D model viewing area. If the scan during stitching is
in obviously incorrect position, it is clear that such scan should be deleted -
select it in the tree and press
Delete
.
Go to ScanMerge for further processing or create a new project to scan the
object from the other side.
Identified markers may appear in the following colors:
Marker found only once
(not reliable)
Marker of the
reference grid
Marker found on several scans
(reliable)
Options
Options
menu displays the properties of the project. Depending on the type of the
project, the number of options may vary.
When
scanning without markers
in
Settings
you may change the parameters for
interception of the model by planes. The scanner is building a 3D model only of those
parts of the object, which fall into the area, limited by near-end and far-end clipping
border. For example, if far-end and near-end borders are 200 and -200mm respectively,
and the scanner is configured to the scan zone 2 with working distance of about 40cm,
the model would be constructed only in the area of 20 - 60 cm from the scanner.
