28
Caution!
If excessive light does not disappear even when the diaphragm is closed, reduce the value
of electronic exposure.
Check the projector settings, probably the light is too bright.
Reduce ambient light level.
If you are setting up the 4th scanning area, it may be necessary to
decrease the brightness of lines and stripes due to the close distance
to object. In the menu
Brightness setup
decrease the brightness value,
as shown in the figure. Brightness value of lines is approximately 2
times greater than the brightness of the stripes. Visually lines and
stripes must be the same brightness.
Caution!
After the end of the setting up procedure carefully lock sharpness and diaphragm rings with
screws on the camera lenses in order not to lose their position.
Upon completion of all scanner adjustments, you should fulfil the following conditions:
●
●
At the same distance focused
and
●
At the standard values of electronic exposure (30-60) image from the cameras is not
excessively bright and not too dark
●
All the adjustment and the clamping screws are tightened
