36
Scanning area
To ensure the quality of the model, the scanner clips it by the
scanning area (the yellow region on the figure below). Scan area is
limited by close and far plane in the Z-axis (depth). Scanning area is set
in the options.
Scanner
→
Options
.
The optimal depth of scan area is approximately equal to the size of
calibration plate on the selected scan area:
L
зс
=D
1-49
For example, for scanning area №2
D
1-49
= 236 mm
Near-end
-D
1-49
/2 = - 118 mm
Far-end
-D
1-49
/2 = - 118 mm
Specify these values in the settings of plane clipping.
Adding new plates
In the menu
Service
→
Full calibration
press the
Edit plates (
see figure below). In the resulting window,
click the
Add
button.
Opens the
"Change the plate parameters".
The cell
1
contains digital value, which has been recorded in the back of the calibration plate. Check the
correctness of data input, this will directly affect the accuracy of the scanner! The cell
2
contains arbitrary
name of the field.
