49
The surface on the scan is "doubling".
The scanner is not calibrated
During scanning edges of the model are rough, with uneven edges.
If the light lines are parallel to the edge of the object, tilt the scanner so that the line crosses the edge at
an angle. Spray edges with matting spray.
During scanning on the rotary table scans are "shredding"
Possible causes:
The axis of rotary table is not evaluated
The position of scanner or table changed after evaluation
The scan object should be mounted in a fixed position on the area, otherwise there may be
slippage of the object when turning the table, which may lead to an error.
During scanning on the rotary table the object is missing lower part
Incorrect value of distance to the central marker: Scanner - Settings. You must set the plater for evaluation
at the rotary table, measure the distance from the table plane to the central mark on the plate and specify
the value (in mm) in
Options
.