43
Incorrect setting up the projector, when structured light created by the software is modified by algorithms
of image improving, embedded in the projector algorithms - this also has a negative impact on the quality of
the model. You need to turn them off.
Scanning without markers
During this scan mode no additional tools are used, but the obtained fragments are not joined, and their
alignment requires more time for the processing of the scan data.
This method is used to scan items, for which you cannot affix markers or move, for example, museum
pieces.
To do this you need the following:
●
Prepare the object (if necessary)
●
Run ScanCenter
●
Create a new project without markers or open an existing one
●
Use the cross to determine the correct distance to object
●
Set the camera exposure by turning on the mode of
Lines and stripes
●
Start scanning
If the scan is unsuccessful - select it in the tree and delete by pressing the Delete button.
Place an object or the scanner in a different position and scan the next fragment. Thus scan the desired
areas of the surface. As you finished, go to the SсаnMerge for further registration and processing the model.
Scanning with markers
This scanning method is more convenient than scanning
without markers. It is the mode the object or supporting
surface is covered with special round marks (markers).
In addition to construction of the object surface, in this
mode the scanner finds marks, determines size and
calculates their coordinates. The size of markers is specified
when creating a new project, or in the Options. If each of
the following scans has enough related marks from
previous ones, new fragment automatically will be placed
in the desired position. In this way, all the pieces will
automatically form a three-dimensional object model,
making it easier for further processing of the scan data,
speeding up the process of obtaining a 3D model.
Found marks form a
reference grid.
You can create a reference grid of markers in advance, and then scan