6 |
P a g e
CONNECTION PROCEDURES
1. Make sure the tank valve is closed (turn
valve clockwise until tight).
2. Check the tank valve to ensure it has the
proper external male threads.
3. Make sure all burner valves are turned
OFF
.
4. Inspect valve connections, port, and
regulator assembly. Look for any
damage or debris. Remove any debris.
Inspect the hose for damage. Never
attempt to use damaged or obstructed
equipment. Contact your local LP gas
dealer for repair.
5. When connecting the regulator assembly to the valve, hand tighten the quick
coupling nut clockwise to a complete stop. Do not use a wrench to tighten. Use of a
wrench may damage the quick coupling nut and result in a hazardous condition.
6. Open the tank valve fully (counterclockwise). Use a soapy water solution to check all
connections for leaks (leak test) before attempting to light the grill (see P.23-24). If a
leak is found, turn the tank valve off and do not use the grill until your LP gas dealer
can make repairs.
TO DISCONNECT LP CYLINDER:
1. Turn the burner valves off.
2. Turn the tank valve off fully (turn clockwise to stop).
3. Detach the regulator assembly from the tank valve by turning the quick coupling nut
counterclockwise.
FLAME CHARACTERISTICS
This procedure outlines how to check for proper
burner flame characteristics.
Burner flames should be blue and stable with little
yellow tips, with no excessive noise, or lifting. If the
flame is yellow, it indicates too much air. If any of
these conditions exist, call our customer service.
Visually check the burner flames prior to each use.
The flames should look like this picture. If not, refer
to the burner maintenance part of this manual.
Summary of Contents for Member's Mark GR2298906-MM-01
Page 7: ...7 P a g e Package Contents...
