27 |
P a g e
fully open. Light all burners and
observe the temperature.
Grill is Too Hot
1. Excess grease build-up
causing grease fires.
2. Damaged or faulty
regulator.
1. Refer to the section of
“Maintenance and Cleaning
instructions
” on pg. 29-32 to
clean the grill properly.
2. Replace the damaged parts with
factory authorized component.
Care & Use Instructions
LIGHTING INSTRUCTION: MAIN BURNER OF THE GRILL
1. Read instructions before lighting.
2. Make sure all control knobs are in the "
OFF
" position.
3. Turn ON gas valve from LP tank.
4. The IGNITION BURNER is the 3
rd
control knob from the left. Light it first. Press and
turn the 3
rd
control knob slowly to "
HI
". Burner should light immediately.
5. If ignition does NOT occur in 5 seconds, turn the burner controls off, wait 5 minutes,
and repeat the lighting procedure.
6. Once the IGNITION BURNER is lit, you may light burners 2, 1 and 4 in this order.
Just press and turn the control knob to
“
HI
”.
Summary of Contents for Member's Mark GR2298906-MM-01
Page 7: ...7 P a g e Package Contents...
