19
Picture 3.1.14A
Picture3.1.14B
3.1.15 Quick hitch system
To change attachments:
Turn on switch No. 7 on the steering column
Use button 1 & 2 on the joystick to lock/unlock the attachments
3.2 Precautions before use
Note
1.Familiar with various control components and their functions;
2.Ensure that all protective measures are properly installed and that all covers are covered;
3.Before starting the machine:
Check the battery status and charge or replace the battery if necessary
Check the engine oil level (refer to the engine instruction manual)
Check the fuel level
Check the oil level of the hydraulic oil circuit. The suitable liquid level should not be lower than the
observation port of the liquid level gauge; below this liquid level, the hydraulic oil should be
replenished, that is, the entire liquid level gauge must be filled with hydraulic oil. If an attachment
with a cylinder or hydraulic motor is used, the liquid level drops.
3.3 Start The Machine
Note
1.Before operating the machine, fasten the seat belt and close the cab door.
2.Be careful when using the machine for the first time, keep the engine running at low speed.
3.After all the inspections are completed, follow the steps below:
S
it
on
the
seat
Click
the
ignition
key
to
preheat
the
engine,
turn
the
ignition
key
to
the
right
to
power
the
vehicle,
and
then
turn
the
engine
to
the
right.
Release
the
key
after
the
engine
starts
to
warm
up
the
engine
If
the
engine
fails
to
start,
wait
a
while
and
try
again
4.The manufacturer's original antifreeze allows the machine to be used at temperatures below minus
