RANS S-20 RAVEN
TEXT
MANUAL
05G-01
ROOT SKIN INSTALLATION
INSTALLATION
(AFTER PAINTING OF WINGS)
1.
Apply desired finish to Root Rib Closeouts.
2.
Final install Root Rib Closeouts and Fuel Sight Gauge parts before the
Wings are mounted to the aircraft.
3.
Refer to ROOT SKIN parts page and place Grommets and Serrated Strip
in correct locations in FWD and AFT Root Rib Closeouts.
HINT: Cut
Serrated Strip slightly long and trim to length to help hold in place.
A few
drops of Super Glue on the outboard side can also help if required. Refer
to
FIGURE 05G-03
.
NOTE: The two Small Grommets are installed only in
the left AFT Root Rib Closeout for the Pitot and Static lines.
4.
Be sure all hardware is installed in fuel tanks for Fuel Withdrawals and
Fuel Sight Gauges. Cleco Root Closeouts to Root Rib. Position Sight
Gauge Decal centered between the Grommets. Refer to
FIGURE 05G-04
.
5.
Install the 90-Degree Fitting for the upper end of the Sight Gauge. Install
the 90-Degree Withdrawal Fitting for the lower end of the Sight Gauge.
Orientate each fitting to align to each other. Fabricate the Sight Gauge
from the supplied Clear Fuel Line. Refer to
FIGURE 05G-05
.
6.
Rivet FWD Root Closeout skin in place.
7.
Route the Flap Teleflex Cable, Fuel Line, and Pitot / Static lines through
the Grommets in the AFT Root Closeout.
8.
Attach Aft Closeout with screws.
9.
Final install the Fuel Lines from the Wing to the Fuselage after the Wings
are mounted. Refer to
FUEL LINE INSTALLATION - FUSELAGE
for
instructions.
0
9/01/2013
