RANS S-20 RAVEN
TEXT
MANUAL
09/01/2013
07A-05
36.
Drill out the lower hole in the Door Handle to 3/16" and press the flange
nut in. Refer back to
FIGURE 07A-33
. Drill the top hole to #28, install the
button head screw and tighten.
37.
Check entire assembly for function.
HYDRAULIC DOOR LIFT INSTALLATION
38.
Install a Ball Stud to the forward side of the welded gusset near the top aft
edge of the Door Frame.
39.
Install a Ball Stud to the forward side welded bushing on Station 3 vertical
tube.
40.
After the wings have been attached, pin the Door Assembly in place on
the Fuselage.
41.
Press end of Gas Spring over Ball Stud on the Fuselage.
IMPORTANT:
The Cylinder portion of the Gas Spring must be oriented upward when
final installed to prevent drying out of the shaft seal during operation.
42.
Press the Ball Stud on the door into the Gas Spring end. Make sure the
Gas Spring is locked in place.
43.
During operation, the Gas Spring may raise the door part way. A gentle
nudge should extend the Gas Spring completely and hold the door in the
full open position. If desired, apply Foam Tape on the bottom of the wing,
where the Door contacts.
