RANS S-20 RAVEN
TEXT MANUAL
09/01/2013
09-01
SEAT BELT INSTALLATION
(AFTER PRIMING OF FUSELAGE FRAME/ BEFORE COVERING)
1.
Prior to covering drill the welded attach bushings to 5/16". Refer to the
parts drawing for attach bushing locations.
(AFTER COVERING AND PAINT OF FUSELAGE)
2.
After the fuselage has been covered and painted, bolt each Seat Belt to
the respective attach bushing as shown in the parts drawing.
3.
Use the elastic bands on the lap belts and lower shoulder belts to hold the
tail of the belts after adjustment has been made.
4.
This seat belt design allows for quick exit out of both lap and shoulder
belts simply by opening the buckle. To use, simply pull belts over lap and
shoulder and adjust.
NOTE: To exit, un-clip lap belt. IMPORTANT: The
shoulder belt must pass over the OUTSIDE shoulder (in either seat) then
diagonally across the chest to the lap belt attach point.
Always make sure
that seat belts are properly positioned and snug prior to and during entire
flight.
CAUTION:
FOR SOLO FLIGHT -
SECURE UNUSED SEAT BELT
