AH-95-02.4
1 1
1 1
1 1
1 1
1 1
The bell and feed tube MUST
MUST
MUST
MUST
MUST be
matched to ensure proper fluid feed into
the bell cavity. The following chart will as-
sist in selecting the proper bell and feed
tube combination:
N O T E
N O T E
N O T E
N O T E
N O T E
@ 2 oclock
@ 4-5 oclock
@ 4-5 oclock
6335-00
3700-00
4076-00
2-3/4
4
6
Bell Size Feed Tube # Position of Tube
Bell Size Feed Tube # Position of Tube
Bell Size Feed Tube # Position of Tube
Bell Size Feed Tube # Position of Tube
Bell Size Feed Tube # Position of Tube
Replacing the plastic set screw with one
of conductive material (metal) will cause a
hazardous condition to exist, capable of
producing an electrical discharge possible of
sparking a fire.
W A R N I N G
W A R N I N G
W A R N I N G
W A R N I N G
W A R N I N G
!!!!!
5.
Attach the proper feed tube (item 12) to
the front of the handgun. Position the
feed tube at about 1 o'clock. See Fig-
ures 1 and 2.
6.
Attach the bell assembly (item 66) to the
front of the handgun. Hold the shaft of
the handgun and rotate the bell onto the
shaft until the bell is completely seated.
Tighten the set screw (item 70) at the
bell hub.
7.
Position the feed tube (item 12) in the
bell cavity at approximately the 4 to 5
oclock position. The feed tube should
NOT
NOT
NOT
NOT
NOT rub on the bell. Adjust the feed
tube if necessary, by rotating it or sliding
it forward or backward in the barrel.
8.
Adjust the high voltage contact brush
(item 41) so that the raised button of
plastic on the brush is rubbing on the
outside back coated surface of the bell
(see Figure 4).
NOTES:
NOTES:
NOTES:
NOTES:
NOTES:
Summary of Contents for 19372
Page 4: ...AH 95 02 4...
Page 61: ...AH 95 02 4 NOTES NOTES NOTES NOTES NOTES...