Packing Removal/Replace
1. Remove barrel from handle.
2. Use 80353 wrench to remove nut.
3. Pull straight out of barrel.
4. Remove jam nuts using 10mm wrench.
5. Remove all parts, clean with non-polar solvent.
Inspect for any discolored areas. Replace parts
as required.
6. Prior to installation apply dielectric grease inside
packing tube, completely full.
7. Insert 4 parts on front of shaft.
8. Insert packing tube onto shaft. Wipe excess grease
over front parts and outside of packing tube.
9. Install rear parts.
AH-15-01.2
32
Ranflex Applicators
-
MAINTENANCE
