Figure 13: Typical Power Supply Mounting
The power supply may be free standing on any
flat surface or wall mounted (wall mount brackets
not supplied) as shown in Figure 13.
>
DO NOT
locate the power supply near
or adjacent to heat producing equipment
such as ovens, high wattage lamps, etc.
C A U T I O N
!
CLASSIC POWER
SUPPLY INSTALLATION
HIGH VOLTAGE CABLE
Position the applicator in the spray area and route
the high voltage cable to the power supply. The
cable should be routed so that it is not damaged
by foot and vehicle traffic and also so that it is
not close to areas of high temperature (129
°
F+).
The operator should have free movement of the
applicator and all bend radii of the cable should not
be less than 6-inches (15cm). Connect the high
voltage cable to the power supply and tighten the
retaining nut and set screw. If during the routing
of the high voltage cable it is required to remove
it from the applicator, care should be taken when
reinstalling so that the clip retaining the high voltage
cable in the applicator is completely engaged and
the high voltage cable retention screw is tightened
to 5-7 lbs•in (.6-.8 Nm) (see Figure 17).
Figure 17: High Voltage Cable Removal and
Installation
>
The power supply must be off when the
applicator is removed or reinstalled.
W A R N I N G
!
Vector AA90 Applicators - Installation
22
AH-07-01.10
