R
ANSOM
&
R
ANDOLPH
3535 Briarfield Boulevard, PO Box 1570 | Maumee, OH 43537 USA
800.253.4502 | 419.865.9497 | 419.865.9997 (FAX) | www.ransom-randolph.com
Investing with Innovation™
Made in the USA
N
EYCRAFT
™
DUPLICATING UNIT
5.
Once you have filled the machine with duplicating material, switch the power on.
NOTE: ONLY OPERATE THE MACHINE WHEN THE LID IS SECURELY IN PLACE.
To avoid serious bodily injury, never place fingers or hands into the machine while it is turned on.
6.
Push the
⑧
RUN button once. Your display screen will display RUN. The machine will heat for approximately 20
seconds before the intermittent stirring begins. The machine will then heat to the melting temperature. Once the
machine reaches the melting temperature, it will automatically begin cooling down to the holding temperature.
Interface: RUN
①
CELSIUS OR FAHRENHEIT
②
STATUS OF THE UNIT
③
REAL-TIME/CURRENT TEMPERATURE IN THE POT
④
TIMER
⑤
ADJUST TEMPERATURE OR TIME UP
⑥
ADJUST TEMPERATURE OR TIME DOWN
⑦
SET
⑧
RUN
Function of this Unit
There are five work functions displayed on the Display Window: Stop Mode Status, Factory Mode Status, Setting Status, Timer
Status, and Running Status. Using the instructions and descriptions below, you can move through each of the functions
depending upon your needs.
Stop Mode Status
Under stop mode, you can enter into different setting modes and set your values using the buttons as shown in the example
below. The picture above (under Interface: RUN) is an example of the Display Window in stop mode.
Stop Mode
Back to Run
Factory Mode Status
Factory mode relates to the temperature measurement reading you choose to use, either °C or °F. You will need to restart the
device to change the factory mode/temperature mode. Where the arrow points represents the
unit’s current
mode, either °C or
°F.
