17
4.7
Digital Input Actions
The two digital inputs (Digital In 0 and Digital In 1) can be configured take a specific action when
activated. An input action can be set for each input. The input action is a number corresponding to the
action performed by the TDD2. Table 7 shows the available actions.
Action Number
Action Performed
0
No Action (Input disabled) Factory Default
1
Increment displayed magnet
2
Decrement displayed magnet
3
Increment gap
4
Decrement gap
5
Increment reference magnet
6
Decrement reference magnet
7
Zero the position by setting the hard offset
8
Zero the position by setting the soft offset
9
Send the current position over the RS-232/485 interface
10
Stop display updates and “hold” the current position.
11
Disable access to the front panel menu
12
Increment the current transducer type
13
Decrement the current transducer type
14
Increment Hard Offset by Preset 1 amount
15
Increment Hard Offset by Preset 2 amount
16
Increment Hard Offset by Preset 3 amount
17
Increment Hard Offset by Preset 4 amount
18
Increment Soft Offset by Preset 1 amount
19
Increment Soft Offset by Preset 2 amount
20
Increment Soft Offset by Preset 3 amount
21
Increment Soft Offset by Preset 4 amount
22
Change hard offset in order to “zero” position to preset 1
23
Change hard offset in order to “zero” position to preset 2
24
Change hard offset in order to “zero” position to preset 3
25
Change hard offset in order to “zero” position to preset 4
26
Change soft offset in order to “zero” position to preset 1
27
Change soft offset in order to “zero” position to preset 2
28
Change soft offset in order to “zero” position to preset 3
29
Change soft offset in order to “zero” position to preset 4
30
Set hard offset to value of Preset 1
31
Set hard offset to value of Preset 2
32
Set hard offset to value of Preset 3
33
Set hard offset to value of Preset 4
34
Set soft offset to value of Preset 1
35
Set soft offset to value of Preset 2
36
Set soft offset to value of Preset 3
37
Set soft offset to value of Preset 4
38
Set Preset 1 to the displayed position value
39
Set Preset 2 to the displayed position value
40
Set Preset 3 to the displayed position value
41
Set Preset 4 to the displayed position value
42
Increment multi-magnet display mode
43
Set magnet offset 1 to preset 1 and magnet offset 3 to
preset 2
