Rapid Spray Buddy Smart Reel® Operators Handbook
Rapid Spray Equipment by Rapid Spray
REVA 19/03/2019
7
PAIRING THE MYPACE HAND-HELD REMOTE TO THE BUDDY
SMART REEL
®
The MyPace hand-held remote should be delivered already paired to the Buddy Smart
Reel
®
. If several reels have been purchased and it is not clear as to which remote is paired to
which reel or if the remote has been replaced, the remote can be re-paired to the reel at any
time.
How to pair a remote
1. Stand within reach of the Buddy® Reel switch panel.
2. Ensure the reel is powered and switched on.
3. Remove the batteries from the remote.
4. Press both buttons on the remote and insert the batteries while holding the buttons.
5. Green lights will flash slowly on the remote and the display on the switch panel on the
reel will slowly flash
PA
.
6. Within 10 seconds, press the manual rewind button on the reel switch panel.
7. Successful pairing will be acknowledged by the display on the switch panel flashing
PA
fast for a few seconds then return to a steady
0
. (The green light on the remote may
continue to flash slowly for a few more seconds then stop).
8. After the green light on the remote stops flashing, press either button to confirm that
the reel is responding.
CUSTOM SPEED ON THE MYPACE HAND-HELD REMOTE
The MyPace function allows a custom rewind speed to be set and stored. It can easily be
re-calibrated as often as needed to suit changing conditions in terrain, weather or each
operator’s personal preference.
1. Pull the hose out to at least 20m.
2. Press both buttons on the MyPace hand-held remote.
3. The Buddy® hose reel will begin to rewind at its minimum speed. The speed will
gradually increase while both buttons remain pressed.
4. When the desired speed is reached, release the button and the reel will continue
at that set speed. (If both buttons are held for approximately 20 seconds the reel will
reach maximum speed).
5. Releasing both buttons will cause the custom speed to be stored in the memory of the
remote.
6. When the
button is pressed the reel will operate at the set speed.
7. The custom speed can be reset as often as needed by starting back at step 2.
